Principles of using organic acids in animal nutrition

Following the European ban of antibiotic growth promoters (AGPs) in 2006, the use of organic acids in animal nutrition has gained significant importance in the feed industry. Their positive effects on feed quality and animal performance have been known for decades and, as they increasingly capture the attention of the feed industry, there is a growing need to define the several acids and their salts as well as to distinguish between their strengths and weaknesses.

The term ‘organic acids’ refers to all those acids built on a carbon skeleton, known as carboxylic acids, which can alter the physiology of bacteria, causing metabolic disorders that prevent proliferation and cause death.

Almost all the organic acids used in animal nutrition, such as formic, propionic, lactic, acetic, sorbic or citric acids have an aliphatic structure and represent a source of energy for the cells. Benzoic acid, instead, is built on an aromatic ring and has different metabolic and absorption characteristics.

The supplementation of organic acids at the right high doses in animal feed can increase the bodyweight, improves feed conversion ratio and reduces colonization of pathogens in the intestine. Specifically, Kirchgessner and Roth (1988) differentiate between different actions, including:

• Decrease of pH value and the buffering capacity as well as antibacterial and antifungal effects in the feed;
• Reduction of pH value by release of hydrogen ions in the stomach, thereby activating pepsinogen to form pepsin and improving protein digestibility;
• Inhibition of gram-negative indigenous microflora in the gastro-intestinal tract;
• Improved energetic utilization in the intermediate metabolism.

The efficiency of an organic acid to inhibit the growth of a microorganism depends on its pKa value, which describes the pH value at which the acid is available 50% in its dissociated and undissociated form respectively. Only in its un-dissociated form the organic acid has its antimicrobial power as they can pass through the walls of bacteria and fungi and alter their metabolism. This means that the antimicrobial efficacy of organic acid is higher in acidic conditions, like in the stomach, and reduced at neutral pH, like in the intestine. Accordingly, organic acids with a high pKa value are weaker acids and therefore more effective preservatives for feed, as, being present in the feedstuff with a higher proportion of their un-dissociated form, can defend feed from fungi and microbes. (Roth and Ettle, 2005). Therefore, the lower the pKa of the organic acid (the higher proportion of dissociated form) the greater is its effect on the reduction of pH and the lower its antimicrobial effect in the more distal portions during its transit through the digestive tract. A strong acid (with low pKa) will acidify the feed and the stomach, but will not have strong direct effects on the microflora in the intestine.

This is one of the reasons why acids like propionic acid, with a high pKa value, are mainly used as preservatives for grain or feed and less for impacting the animal performance directly, whereas formic or lactic acid are mainly used to improve digestibility processes. Additionally, there are some specific effects against yeasts, moulds and bacteria of each acid, which cannot be explained by the pKa value. Strauss and Hayler (2001) marked differences in the inhibitory effect of several organic acids on bacteria (Table 2).

The MIC values in Table 2 reflect the activity of different organic acids against gram-negative and gram-positive bacteria determined under in vitro conditions.

A research study by Strauss and Hayler (2001) on lactic acid showed that low concentrations of applied acid can lead to the stimulation of growth of Clostridium perfringens when lactic acid was used at a dosage below 0.20%.

Other authors found enhanced development and increased mycotoxin formation when propionic, benzoic and sorbic acids were used at subinhibitory concentrations (Müller et al., 1981, Uraih et al., 1977, Spicher and Westenhoff, 1985).

Formic acid is not suitable to suppress moulds in compound feeds or grain as it may promote the growth of aflatoxin-forming Aspergillus species (Petterson et al., 1989). Thus, its use to treat aerobically stored high-moisture grains is prohibited in the EU if the additive contains >50% of formic acid.

In general, considerably higher dosages - depending on species - are needed in animal feed to get measurable effects on animal performance, because under in vivo conditions factors such as crude protein content, total buffering capacity, environmental conditions and age and health status of the animals play an additional influencing role.

To maximize the direct effect of organic acids against pathogens, it is a precondition that the acid molecule and the pathogenic microorganism get in contact. This means that the active ingredient of an organic acid has to reach the place where pathogens are located, which could either be the feed or the stomach, but in most cases it is the intestinal tract. Bacteria like E. coli and Salmonella ssp. are located in the small intestine. Under in vivo conditions and by using a practical dosage of 5 kg liquid formic acid (85% active ingredient) per ton of compound feed, Kirsch (2010) only found 5.5% of the active ingredient in the small intestine.

Similarly, Maribo et al. (2000a) only detected 4.4% of active ingredients in the small intestine by using a dosage of 0.7% liquid formic acid in the diet. She tested as well benzoic acid by using 2% benzoic acid in the first piglet diet (week 4-6) and 1% benzoic acid in the second piglet diet (week 6 -10). She found a much higher level in the intestine as 22% of benzoic acid was found in the last third of the small intestine (Maribo et al. 2000b).

All pure liquid organic acids are corrosive products. Even if these liquid acids are sprayed on a carrier, the product can be corrosive - depending on the active ingredients-. Salts of organic acids, like calcium propionate, sodium formate or sodium benzoate seemed a good option to add active ingredients in a solid and non-corrosive form. The use of organic acid salts represents a nice tool given that the concentration of cations (e.g. Ca2+, Na+) added by the salt is considered in the diet formulation, thereby reducing the buffering capacity of the compound feed.

However, the mode of action of organic acids (Figure 1) depends on free hydrogen ions to activate the organic molecule into the dissociated or un-dissociated form respectively. Unlike organic acids, salts do not have an hydrogen ions to release.

The chemical fact: “the stronger acid releases the weaker one from its salts” is still valid and can be illustrated by the following reaction: